![]() Note: The controls of this panel are available only in Default Morph Settings, or if you have selected one or more entire Morph elements (no sub-elements).īottom Offset to Home Story: Enter a value here for the Morph’s elevation from the Home Story. The total number of editable items is shown in the Model Panel as well as in the Info Box. If you have selected an entire Morph plus any additional faces or edges, you will be able to edit sub-element options only: all the sub-elements of the entire Morph, plus the additional selected sub-elements.Īgain, only the Model Panel of Morph Selection Settings is available, and only the Face Surface, Texture Mapping, and Edge Type can be edited. ![]() Morph Selection Settings: Whole Morph plus Faces and/or Edges The numbers of editable faces and editable edges, if any, are shown in the Model Panel as well as in the Info Box. The rest of the controls (Morph Shadows) are gray, because these options can be applied here only to the Morph as a whole, not to its selected sub-elements. In this case, only the Model panel is available, and the only available controls are Override Surface and Texture mapping (if any faces are selected) and Edge Type (if any edges are selected). Use sub-element selection to select any combination of particular edges and faces from any number of Morphs to edit them. Morph Selection Settings: Faces and/or Edges For a Morph as a whole, the texture mapping is always “Box.” If you have selected the entire Morph, all controls of Morph Settings are available:Įxception: Texture Mapping (either Box or Planar) can only be modified for selected individual faces. Settings are shown for the last-selected face or edge, but when you change the options, they are applied to all selected faces and/or edges. one or more of its sub-elements (faces and/or edges),. ![]() Morph Selection Settings vary depending on whether you have selected Morph Default Settings enable you to set parameters for Morphs to be created. įor general information on how to create and edit Morphs, see Morphs. Continued abuse of our services will cause your IP address to be blocked indefinitely.For a description of generic settings common to all tools in the Toolbox, see Working in Tool Settings Dialog Boxes. Please fill out the CAPTCHA below and then click the button to indicate that you agree to these terms. If you wish to be unblocked, you must agree that you will take immediate steps to rectify this issue. If you do not understand what is causing this behavior, please contact us here. If you promise to stop (by clicking the Agree button below), we'll unblock your connection for now, but we will immediately re-block it if we detect additional bad behavior.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |